Einfach überzeugend
Overview of function parameters
Quick guide to initial commissioning
Quick guide to initial commissioning
Error messages at a glance
MCS series 2008 to 2019 with membrane keypad - Explanation of parameters and functions
MCS series 2008 to 2019 with 4” touch display - Explanations of parameters and functions
MCSe series up to 2019 - Explanations of parameters and functions
Operating and diagnostic software with 15” touchscreen IPC
Operating software with 7” touch display
hot runner controller for simple applications
Explanations of modules and parameters
CR15 - Explanations of modules and parameters
CR15plus - Explanations of parameters and functions
FP08 - Explanation of parameters and functions
FP08 for Profibus - Explanations of parameters and functions
FP16 - Explanations of parameters and functions
FP16plus - Explanations of parameters and functions
FP160 - Explanations of parameters and functions
SC500 - Explanation of parameters and functions
All parameters and functions of the AT266 explained
All parameters and functions of the AT265 explained
All parameters and functions of the AT267 explained
AT065 Single-channel strain gauge amplifier
Process visualization software for all Feller control devices
Explanations on the interface converter
Technical data of the solid state relays
This free parameterization software under Windows® supports all FELLER ENGINEERING devices with standard FE3 protocol and integrated interface up to 64 control zones.
When using an RS485 interface, the SI13u interface adapter is required to perform the conversion from USB to the RS485 interface of the controllers.
Update Visual Fecon to the current status
Small program for configuring the IP address on our controllers and regulators which are equipped with an Ethernet interface.
Small VB5 / VB6 project to control devices via the FE3 protocol. Complete with source code. The MSCOMM32.OCX is required, as well as an automatic level converter RS232->RS485 (e.g. SI13u) if required. This project is primarily aimed at programmers who are faced with the task of writing their own routines for protocol adaptation. The checksum generation is also illustrated here.
GSD file for communication with FELLER ENGINEERING controllers with integrated Profibus interface.
GSDML file for communication with FP160 and FP1600 controllers via ProfiNET.
SDDML file for communication between FP160 and FP1600 controllers via Sercos III
The complete process visualization for installation under Windows®.
All currently supported VISUAL FECON device drivers for installation under Windows®.